...
Note: Functions in the side panel are disabled when in measure mode in order to prevent conflicting actions.
...
Measurement mode
Click [Measurement button] on the sidebar to activate measure mode, and the toolbar appears to the right next to it.
Click on a point to start measuring. By default, measurements are made from the floor as a reference.
Click the next point of measurement. A dotted line that follows the pointer will extend from the first point. The line will change into a blue vertical line on the vertical axis. Also for mid-air measurement, the line will mesh.
Continue the measurement by creating a polyline, or click [check button] to finish creating the lines. * You can also end the Polyline measurement by snapping the last point onto the first point.
The total length of your polyline measurement will display in the distance display on top of the main screen.
Click the [Save] button on the left-bottom of the screen.
To edit the created line object, click the [Hand] button to select the object. Click on a vertex and drag it to the desired position.
...
Measurement_edit line object
8. To delete a line object you have created, click the [Hand] button, select the object you want to delete, and then click the [Trash bin] at the bottom-center of the screen. If you want to delete all at once, click the [Broom] button.
...
Edit mode
Measurement_select
| Info |
|---|
Tip:
|
Note: How to measure the width of the top plate
Ex) Measurement of the part away from the floor
1. Click on floor #1 in the image below. Drag the mouse to corner #2 in the image below by holding down the [shift key]. *Thevertical line is indicated with a blue dotted line.
2. Click on the #2 and release the [shift key] to drag the mouse to corner #3. *The horizontal axis is indicated with a white dotted line.
3. Click on the #3
4. Click on the [Check button] to finish creating the line.
*In the image below the [Magnifing Magnifying zoom] button is activated.
...